- Create larger printouts using multiple 8-1/2 x 11" pieces of paper. (Oops. All the tools are there with native Adobe PDF reader.. need a bit of work here.)
- Consider Max / Min calculations so drawings center on the page better. In fact we can use max/min to determine paper sizing.
- Improve the round to square tube tool to display square tubing 2T corners
- Make site fully functional, including printing, from a mobile browser (tablet, phone).
POSSIBLE FUTURE ENHANCEMENTS:
And in no particular order, here are some possible future enhancements:
[General Fab] Rectangular tube to rectangular tube, at different angles, rotations and offsets, complete with accurate corner fillet radius.
I will say, this one is incredibly hard to do. My head hurts just thinking about it.
[Bicycle] Compound miter joints on a single part -- Specifically the down tube overlaying both seat tube and bottom bracket...
(Personally I think this one may be a bad idea for a beginner learning processs, but I do want to solicit comments & ideas.)
[General Fab] Here's an out of the box idea: Add tig torch parameters to the paper output.
(tungsten size, amperage settings, argon rate, etc...) I've never touched a MIG gun, so I don't know it that is even applicable.
[Bicycle] Segmented Crown Front Fork Calculator.
[General Fab / Automotive] Segmented / Mitered tubing bends
[General Fab] Pipe blanking orange peel segments
[General Fab] Rectangular Tubing with Coped Radius corners
[General Fab] Angle Iron Notched Joint
[Bicycle] Seat Tube / Seat Post Joint, allow for interference
[General Fab] Angle Iron 90 degree formed bends
If you have any questions or comments on the TubeNotcher Software program, you can contact the author via email: [email protected]